|
|
DynaSet Drop-In Anchors
Product Advantages
| > |
Flush fitting with no protrusion when not in use |
| > |
Shallow embedment, hence less chance of drilling into rebar, and faster drilling |
| > |
Removal of fixture leaves anchor undisturbed |
| > |
Setting tool stamp marks to indicate complete expansion |
| > |
Visual expansion check with setting tool |
| > |
Permanent anchorage point in solid concrete, brick or masonry |
| > |
Can be used with all types of bolts, screws and studs |
| > |
Available in carbon steel and stainless steel AISI 316(A4) or AISI 304(A2) |
Applications
| > |
Mechanical and electrical services |
| > |
Suspension systems (ceilings) |
| > |
Cable Trays |
| > |
Signs |
| > |
Hand rails |
| > |
Drill the correct diameter hole and depth. |
| > |
Clean the hole with a brush and blow out pump. |
| > |
Push the anchor into the hole. |
| > |
Insert the relevant setting tool of the same diameter as the anchor until it makes contact with the cone. Use a hammer to drive the setting tool into the anchor – stop hammering when the expander shoulder rests against the anchor or when it is blocked (in hard concrete). |
| > |
Tighten to the recommended torque using a torque wrench. |
Product Range
| |
Type |
Sizes |
 |
Zinc Plated |
M6 to M20
5/16" to 6/8"
|
 |
Stainless Steel A4 or A2 |
M6 to M20 |
 |
DynaSet setting tools |
M6 to M20 |
|
|
Product pages - Drop-In Anchors.pdf